One of most difficult parts of kitchen remodeling is logistics. Where does everything go? The clean slate of a new kitchen can be overwhelming. In a remodel, limitations might include square footage and existing plumbing placement (relocating plumbing is typically not a cost-effective option for most upgrades).
To begin designing your kitchen remodeling project, take exact measurements of available floor space, then place the basic elements. Use these guidelines:
• Doorways and walkways: Any doorway into the kitchen must be at least 32 inches wide, and swinging doors shouldn’t interfere with appliances, cabinets, or other doors. In a small kitchen, hang doors so they swing out, rather than in, to avoid clearance problems. Passageways through the kitchen should be at least 36 inches wide. In work areas, walkways should be at least 42 inches wide for one cook or 48 inches for multiple cooks.
• Work triangle: The work triangle is an important design concept that improves a kitchen’s functionality by minimizing walking distance between the sink, refrigerator, and primary cooking surface. For comfort and safety, the sum of the three distances should be no more than 26 feet, and each stretch of the triangle should measure between 4 and 9 feet.
If two or more people cook at the same time, plan triangles for each cook. These triangles might share one leg, but they should not cross each other. Also, try to avoid having major traffic walkways cross through the triangle.
• Sink and dishwasher: Flank any sink with landing areas of at least 24 inches on one side and at least 18 inches on the other. If your kitchen will have a secondary sink, allow at least 3 inches of countertop on one side and 18 inches on the other. Place the nearest edge of the dishwasher within 36 inches of the nearest edge of a sink, preferably the primary prep sink. Also, leave at least 21 inches between the dishwasher and any adjacent appliances, cabinets, or other obstacles.
• Counters: Designers recommend that a kitchen include at least 158 total inches of usable countertop, which is considered any span, including islands, that is at least 24 inches deep and has at least 15 inches of clearance above. It’s recommended to include at least a 24-inch-wide span of countertop next to a sink for prep work. Plan for at least 15 inches of countertop beside the handle side of the refrigerator or on either side of a side-by-side refrigerator. Allow at least 12 inches of countertop on one side of a cooking surface and 15 inches on the other.
If the appliance is in an island, also extend the countertop at least 9 inches beyond the burners. For a separate oven, include a 15-inch span of countertop on either side. When these countertop areas overlap, take the larger of the two guidelines and add 12 inches.
• Seating: When a countertop doubles as a seating area, a 28-30-inch-wide space per diner is most comfortable. Also plan for 18-inch-deep knee space for 30-inch-high counters, 15 inches for 36-inch counters, and 12 inches for 42-inch counters. Allow a 36-inch clearance behind chairs or stools, measured from counter/table edge to the wall or obstruction. If there is a walkway behind the diner, allow 44-60 inches for comfortable passage.
Kitchen Remodeling – Electrical and Ventilation
All receptacles servicing countertop areas require GFCI (ground-fault circuit interrupter) protection. A kitchen must have at least one wall-switch controlled light, with the switch placed at the entrance. At least 8 percent of the total square footage of the kitchen must be windows or skylights. It’s also important to have task lighting over every work surface.
For all cooking surface appliances, install an outdoor-venting ventilation system with an exhaust rate of 150 cubic feet of air per minute. Install range hoods or microwave-hood combos at least 24 inches above a stove or according to manufacturer instructions. If a microwave is placed below the countertop, the bottom must be at least 15 inches off the floor. Allow 15 inches of clear space above the refrigerator.
Kitchen Remodeling – Safety Issues
Kitchen remodeling has the potential to cause harmful, even fatal, injuries with the danger of fires, scalding, cuts, and falls. Protect your family by keeping a fire extinguisher visible, easily accessible, and away from cooking equipment. Make sure the extinguisher is rated for Class B fires, test the equipment at least every six months, and make sure everyone in the family knows how to use it.
Don’t place a cooking surface under an operable window and never use flammable window treatmentsabove a stove top or oven. Also, choose clipped or rounded corners for countertops, which are safer than sharp edges.
Kitchen Remodeling – Storage and Accessories
Although building codes don’t address kitchen storage or accessories, they are nonetheless important concerns.
Designers recommend a rough guideline of including a minimum of 117 feet of shelf and drawer frontage and at least 167 feet in a large kitchen (greater than 350 square feet).
How to Calculate:
Calculate frontage by multiplying cabinet width in inches by the cabinet depth in feet and then by the number of shelves. Of this total, include at least 33 feet within 72 inches of the main sink’s centerline or at least 47 feet in a large kitchen.
If you have corner cabinets, it’s advisable to include a lazy Susan, pullout shelving, or other usable storage device. Finally, place a trash can under each sink or near the primary prep area. If possible, include a second bin in the same area for recycling.
By Kathy Barnes from Better Homes and Gardens
Interested in kitchen remodeling? Contact Medina Exteriors today, (330)591-4040